With cutting-edge technology, these Full Film High Voltage AC Filter Power Capacitors enable efficient energy transmission, reduced line losses, and increased grid reliability.

Internally Fused Capacitor Units

Environmentally acceptable proprietary dielectric fluid that provides an ideal balance between low- and high-ambient temperature operation

。Voltage level: 1 ~ 24kV

。Capacity level: 100 ~ 800kvar

。Capacitance deviation: -3% ~ +5%

。Dielectric loss tangent value: ≤0.03%

Read More

Unfused Capacitor Units

Unfused capacitor units refer to capacitors that are not equipped with a fuse for protection. Fuses are often used in capacitor units to protect against overcurrent or short-circuit conditions that could lead to damage or failure of the capacitor.

。Voltage level: 1 ~ 24kV

。Capacity level: 100 ~ 800kvar

。Capacitance deviation: -3% ~ +5%

。Dielectric loss tangent value: ≤0.03%

Read More

Surge Protection Capacitor Unit

Internally fused capacitor units are capacitors that have built-in fuse protection to prevent catastrophic failure in the event of a short circuit or overload.

。Voltage level: 6~35kV

。Capacity level: 0.1 to 0.5μF

。Capacitance deviation: -3 ~ +10%

。Dielectric loss tangent value: ≤0.03%e

Read More

AAM AC filter Power Capacitor

。Environment temperature: -40 ~ +45℃
。Height: ≦1000m
。For bandpass filter, the deviation of actual and the rated capacitance are less than ±5%.
。For high-pass filter, the deviation of actual and the rated capacitance are less than ± 7.5%.

Read More

BAM single and three phase Power Capacitor

。Rated voltage: 6.3kV, 6.6kV, 6.6/√3kV, 7.96kV, 10.5kV, 11kV, 11kV, 11/√3kV, please indicated in the order if you want the other special capacity.
。Rated capacity: 33~334kvar please indicated in the order if you want the other special capacity.
。Capacity tolerance: -5 ~ 15%.
。Loss angel tangential value: film & papaer medium tg θ≦0.08%,film medium tg θ≦0.05%.

Read More

BAM three phases High voltage Power Capacitor

Altitude: less than 1000m; Ambient Temperature: -40℃ ~ +40℃。
No violent mechanical vibration, no harmful gas and vapor, no electric, and explosive, and explosive dust in location.
Continuous operation voltage: 1.00 Un, long-term max, Over voltage: less.1 Un.
Stable over-curent (including harmonics current) less 1.3 In.

Read More

Power Factor Correction Capacitors Square Type

Power factor correction capacitors are square type capacitors that are used to improve the power factor of electrical systems.

。Rated Voltage: 230V, 400V, 450V, 480V, 525V, 690V, 750V, 1200V, other custom voltages available;
。Rated Capacity: 1kvar to 60kvar for 0.4~0.69kV, other custom capacities available;
。Rated Frequency: 50Hz or 60Hz;
。Capacity Tolerance: -5% to +10%;

Read More

Power Factor Correction Capacitors Cylindrical Type

。Rated Voltage Level (kV): 0.23, 0.25, 0.4, 0.45, 0.48, 0.525;
。Rated Capacity (kvar): 1~50;
。1~10kvar: Single-ended terminal;
。12.5~30kvar: Screw terminal;
。35~50kvar: Delta terminal(<400V);Screw terminal(>400V)
。Capacitance Deviation (uF): -5% to +10%;
。Loss Tangent (tanφ): <0.1% (at Un, 50Hz, 20℃);

Read More

Split-Phase Capacitors

With the development of reactive power compensation technology, for three-phase unbalanced loads, the method of separately switching capacitors for each phase can be employed to compensate for the reactive power of each phase.

This approach enhances compensation accuracy and improves energy-saving effects. To achieve this, our company has developed a parallel capacitor configuration that enables both phase-by-phase and inter-phase compensation, facilitating the selective switching of capacitors for different phases.

Read More

ANTI-Harmonic Capacitors

These capacitors possess a higher ability to withstand currents and are connected in series with reactors to suppress harmonic current amplification and prevent resonance. Additionally, this product functions as a reactive power compensator.

。Rated Voltage Levels (kV): 0.45, 0.48, 0.525.
。Rated Capacity (kvar): 15~60.
。Capacitance Deviation (μF): 0~+3%.
。Dissipation Factor (tanδ): ≤0.1% (at Un, 50Hz, 20℃).

Read More

AC-Filter Capacitors

。Rated Voltage Levels (kV): 0.33, 0.45, 0.48, 0.525, 0.80
。Rated Capacity (kVar): 15~100
。Capacitance Tolerance (μF): 0~+3%
。Loss Tangent (tanδ): ≤0.1% (at Un 50Hz 20℃)

Read More

Resonant Capacitors

。High capacity, high bit characteristics
。Fully water-cooled, semi-water-cooled
。Environmentally friendly medium
。Pressure protection
。Altitude: <2000m
。Ambient Temperature: 5℃~45℃
。Relative Humidity: ≤85%
。Capacity Deviation: ±5%
。Rated Voltage: 1-3.4kV

Read More

DZMJ DC Filter Capacitor

The role of DZMJ DC filter capacitors is to provide filtering and voltage support on the direct current (DC) side of the power supply.

。Large capacity: 300~5000μF
。High current: Maximum current reaches 2500A
。High voltage: 800~1800VDC
。Cooling method: Full water cooling or semi-water cooling
。 Non-toxic impregnating agent
。 Equipped with pressure protection relay

Read More

Protecting Absorption Capacitors

In power supplies where thyristors are used as switches, they are connected in series with resistors to form an RC absorption protection circuit. This circuit prevents voltage spikes during thyristor turn-off, thereby protecting the thyristors.

。Altitude Environment: <2000m
。Temperature Range: -25 to +40°C
。Humidity Level: <85%
。Protection Rating: IP00 for indoor installation

Read More

A high voltage power capacitor is an electrical component used to store and release electrical energy in high voltage applications. It is designed to handle and store large amounts of electrical charge.

Here are some key points about high voltage power capacitors:

Function: The main function of high voltage power capacitors is to store electrical energy and release it when needed. It acts as a temporary energy storage device in electrical systems.

Applications: High voltage power capacitors are commonly used in various industries and applications. They are widely used in power transmission and distribution systems, power substations, industrial machinery, renewable energy systems, and high-power electronics.

Construction: These capacitors are usually made with special materials and designs to withstand high voltage levels. They consist of two conducting plates separated by an insulating material called a dielectric. The dielectric materials used in high voltage capacitors are specifically selected for their ability to handle high voltage stress.

Voltage Rating: High voltage power capacitors are designed to handle higher voltage levels than standard capacitors. Their voltage ratings range from a few kilovolts (kV) to hundreds of kilovolts (kV) or even megavolts (MV), depending on the application.

Professional Molded Case Or Vacuum Circuit Breaker and Power Capacitor manufacturer
ZHIYUE GROUP CO.LTD is a factory who mainly produce power capacitor, intelligent reactive compensation controller, vacuum circuit breaker , high and low voltage power transformer, high and low voltage reactive compensation device, harmonic solving device. It is a company which integrate research, produce, trade , service as a unit.
32+ Years
Of Experience
6800㎡
Workshop Area
300+
Technical Personnel
7*24
Quick Answer
News Center

Power Capacitor as the Key Power in the Electric Power System

What are the main performance characteristics of vacuum contactors?

What is the purpose of power capacitors?

What is the difference between a vacuum circuit breaker and an ordinary circuit breaker?

Can't find what you're looking for?
In the past 32 years, Zhiyue Group Co., Ltd. has been helping many well-known companies and organizations to provide high-voltage power capacitors, low-voltage capacitors, vacuum contactors, vacuum circuit breakers, high-voltage load switches, high-voltage disconnect switch, high voltage transformer.
Contact Our Experts
Message
Cell Phones Telephone E-mail

Back To Top

Leave Message Here!
GET IN TOUCH NOW
×
We value your privacy
We use cookies to provide you with a better online experience, analyse and measure website usage, and assist in our marketing efforts.
Accept All